资 源 简 介
SS5 Series Hall effect posiTIon sensors are operated by the magneTIcfield from a permanent magnet or electromagnet. The small SOT89 stylepackage surface mounts on PC boards and flexible circuits. The SS5 usesa industry standard "gull-wing" design which makes it less suscepTIble to"solder bridging" and allows increased circuit board density. The SS5series package can accommodate larger IC’s than SS1 and allows for fourpindesignsThe integrated circuits are designed to provide predictable performanceover the full temperature range of -40 to +150°C. Bipolar, unipolar andlatching magneTIcs are available. The SS5 has the same footprint and pinoutas the industry standard SOT-89. It will replace Honeywell SS1 Seriesand any equivalent SOT-89 sensors from other suppliers with minimum orno design changes.On-board regulation provides extremely stable operation over the fullsupply voltage range of 4.5 to 24 VDC(SS51T) or 3.8 to 30 VDC(SS500).Current consumption is a low 10 mA maximum at 40°C and is typically7mA or less at room temperature and above. SS5 sensors are capable ofcontinuous 20 mA sinking output, and can withstand temporary current ashigh as 20 mA maximum (SS51T) or 50 mA maximum (SS500). They canuse existing power supply sources in most applications, and can be directlyinterfaced with many electronic components without buffering orcompensation circuitry.SS5 Series sensors are supplied on tape and reel for high-volume,automated pick and place equipment. Each reel contains 1,000 sensors.MICRO SWITCH supplies bar and ring magnets for operating Hall effectsensors. Bar magnets can operate any Hall effect sensor. Ring magnetsare magnetized on the outside diameter with alternating North and Southpoles. They are particularly useful with bipolar sensors and rpmmeasurement.
